2000 Dodge Ram Recalls & Complaints

DEALERS WILL INSPECT THE ABS CONTROL MODULE CONNECTOR FOR ELECTROLYTE DAMAGE AND REPLACE THE CONNECTOR AS NECESSARY. THE RECALL WILL BEGIN ON SEPTEMBER 27, 2004. OWNERS SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

ON CERTAIN VAN AND WAGON VEHICLES EQUIPPED WITH 4-WHEEL ANTILOCK BRAKE SYSTEMS (ABS), AFTERMARKET BATTERIES MAY LEAK ELECTROLYTE ONTO THE ABS CONTROL MODULE CONNECTOR, WHICH CAN COMPROMISE SEALING INTEGRITY OF THE CONNECTOR.

OWNERS WILL RECEIVE INSTRUCTIONS FOR REMOVING THE CIRCUIT BREAKER FROM THE FUSE PANEL. IF AN OWNER DESIRES, THEIR DEALER CAN PERFORM THE REPAIR. OWNER NOTIFICATION BEGAN AUGUST 27, 2001. OWNERS WHO DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

VEHICLE DESCRIPTION: VANS AND WAGONS NOT EQUIPPED WITH POWER FRONT SEATS. IN THE PRESENCE OF ROAD SALT, WATER, AND POSSIBLY OTHER DEBRIS, THE POWER SEAT CONNECTOR LOCATED BENEATH THE DRIVER'S SEAT COULD DEVELOP A HIGH RESISTIVE SHORT CIRCUIT THAT CYCLES THE CIRCUIT BREAKER.

K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.

K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

AAI MOTORSPORTS WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 1, 2006. OWNERS MAY CONTACT AAI MOTORSPORTS AT 909-923-9188.

CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

ALL OF THE DEFECTIVE TOW PACKAGES ARE STILL AT THE DISTRIBUTOR LEVEL AND HAVE NOT BEEN SOLD TO ANY CONSUMERS.

CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY.

DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL.

DEALERS WILL REPLACE THE FRONT BRAKE HOSE ASSEMBLIES, AND THE ABS SENSOR WIRE WILL BE INSPECTED AND REPLACED IF NECESSARY. OWNER NOTIFICATION BEGAN MARCH 8, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH AN ANTI-LOCK BRAKING SYSTEM (ABS). SOME VEHICLES MAY HAVE INADEQUATE CLEARANCE BETWEEN THE FRONT TIRE/WHEEL AND THE BRAKE HOSE/ABS SENSOR WIRE ASSEMBLY. DURING FULL LOCK TURNS, IT IS POSSIBLE FOR THE TIRE OR WHEEL TO CONTACT THE BRAKE HOSE/ABS SENSOR WIRE ASSEMBLY.

DEALERS WILL INSPECT THE TRAILER HITCHES AND REPLACE ANY TRAILER HITCH SHOWING SIGNS OF FATIGUE CRACKING. IF NO EVIDENCE OF CRACKING EXISTS, THE DEALER WILL INSTALL TWO REINFORCEMENT BRACKETS.

VEHICLE DESCRIPTION: PICKUP TRUCKS EQUIPPED WITH OPTIONAL TRAILER HITCH. THE TRAILER HITCH SIDE BRACKETS WERE MANUFACTURED USING MATERIAL WITH INSUFFICIENT STRENGTH.

DEALERS WILL REPLACE THE FRONT AXLE WITH A PROPERLY WELDED FRONT AXLE.

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS. THE WELDS AT THE RIGHT SIDE LOWER CONTROL ARM BRACKET TO AXLE TUBE ATTACHMENT MAY HAVE INADEQUATE FATIGUE LIFE DUE TO POOR WELD QUALITY. THIS CAN LEAD TO SEPARATION OF THE CONTROL ARM BRACKET FROM THE AXLE TUBE.