IF THIS CONDITION OCCURS IN THE AREA OF THE FUEL INJECTION PUMP, THE ENGINE STARTER COULD SHORT CIRCUIT IF THE CLAMP DROPS ONTO THE STARTER TERMINAL.
Remedy & full details
DEALERS WILL REMOVE EACH CLAMP AND INSPECT FOR RUBBER DETERIORATION AND WILL REPLACE THE CLAMP IF THE RUBBER DETERIORATION IS EVIDENT. DEALERS WILL REPLACE THE ATTACHING HARDWARE AND APPLY ADHESIVE TO PREVENT THE BOLTS/NUTS FROM LOOSENING AND INSPECT FOR A RUBBER CAP ON THE STARTER MOTOR'S TERMINAL AND INSTALL A CAP IF ONE IS NOT PRESENT TO PREVENT A SHORT CIRCUIT. THE RECALL BEGAN ON JANUARY 13, 2005. OWNERS SHOULD CONTACT MITSUBISHI FUSO AT 1-877-711-0707.
ON CERTAIN TRUCKS, THE RUBBER PORTION OF THE FUEL INJECTION PIPE CLAMPS COULD DETERIORATE. NORMAL VEHICLE OPERATION COULD CAUSE THE DETERIORATED CLAMP TO LOOSEN AND DRIP.
Serious02V029000
Service Brakes, Hydraulic:Power Assist:Vacuum
IF THE SHAFT BREAKS, BRAKING DISTANCE WOULD BE EXTENDED DUE TO THE LACK OF BRAKE BOOSTER FUNCTION, raises the risk of A CRASH.
Remedy & full details
DEALERS WILL INSPECT AND REPLACE THE VACUUM PUMP SHAFT ASSEMBLY. OWNER NOTIFICATION BEGAN FEBRUARY 15, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MITSUBISHI FUSO TRUCK AT 1-856-467-4500.
ON SOME HEAVY DUTY TRUCKS, THE VACUUM PUMP SHAFT BREAKS DUE TO INSUFFICIENT HEAT TREATMENT.
Serious09E010000
Exterior Lighting:Headlights
THE PURPOSE OF THIS STANDARD IS TO REDUCE DEATHS AND INJURIES FROM MOTOR VEHICLE CRASHES BY PROVIDING ADEQUATE ILLUMINATION OF THE ROADWAY.
Remedy & full details
MFTA WILL NOTIFY OWNERS AND REPLACE THE HEADLAMPS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 15, 2009. OWNERS MAY CONTACT MFTA AT 1-856-467-4500.
MITSUBISHI FUSO TRUCK OF AMERICA (MFTA) IS RECALLING 156 HALOGEN SEALED BEAM HIGH BEAM HEADLAMP ASSEMBLIES SOLD BETWEEN OCTOBER 24, 2007 AND DECEMBER 2, 2008 FOR USE AS REPLACEMENT EQUIPMENT FOR CERTAIN MITSUBISHI FUSO TRUCKS. THESE LAMPS FAIL TO CONFORM TO THE SAE STANDARDS OR RECOMMENDED PRACTICES REFERENCED IN TABLE I OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
Serious04V571000
Parking Brake:Conventional:Mechanical:Linkage And Cable
IN THIS CONDITION, THE PARKING BRAKE CABLE MAY BEND AND BREAK DUE TO FATIGUE.
Remedy & full details
DEALERS WILL INSPECT THE PARKING BRAKE CABLE FOR BENDING OR DAMAGE AT THE CABLE END AND INSTALL A MODIFIED PARKING BRAKE CABLE ASSEMBLY IF THE CABLE IS BENT OR DAMAGED AT THE CABLE END. IF NO BENDING OR DAMAGE EXISTS, DEALERS WILL INSTALL A CABLE RETAINER ON THE CABLE END OF THE PARKING BRAKE CABLE. THE RECALL BEGAN ON JANUARY 13, 2005. OWNERS SHOULD CONTACT MITSUBISHI FUSO AT 1-877-711-0707.
ON CERTAIN TRUCKS, THE CABLE END OF THE PARKING BRAKE CABLE, WHERE IT ATTACHES TO THE PARKING BRAKE LEVER, IS DESIGNED IMPROPERLY. REPEATED NORMAL PARKING BRAKE OPERATION MAY CAUSE THE CABLE END TO BECOME IMPROPERLY SEATED IN THE PARKING BRAKE LEVER GROOVE.
Serious07V138000
Engine And Engine Cooling
THE ENGINE COULD STALL AND WOULD NOT RESTART raises the risk of A CRASH.
Remedy & full details
ON VEHICLES WITH LESS THAN 15,000 MILES, IF THE IDLER GEAR AND BUSHING ASSEMBLY, IDLER GEAR SHAFT AND BOLT WILL BE REPLACED. IF THE MILEAGE IS MORE THAN 15,000 MILES, THE INSIDE DIAMETER OF THE IDLER GEAR BUSHING WILL BE MEASURED AND IF THE BUSHING MEASURES MORE THAN 32.043MM (1.262"), THE IDLER GEAR AND BUSHING ASSEMBLY, IDLER GEAR SHAFT AND BOLT WILL BE REPLACED. THE RECALL BEGAN ON AUGUST 13, 2007. OWNERS MAY CONTACT MITSUBISHI FUSO AT 1-856-467-4500.
ON CERTAIN TRUCKS, THE CYLINDER HEAD IDLER GEAR BUSHING MAY HAVE BEEN IMPROPERLY MACHINED, CAUSING EXCESSIVE STRESS ON THE CYLINDER HEAD IDLER GEAR SHAFT. CONTINUED OPERATING IN THIS CONDITION COULD CAUSE THE IDLER GEAR SHAFT FLANGE TO BREAK AND GENERATE ABNORMAL ENGINE NOISE OR ENGINE OIL LEAKS.
Serious05V451000
Engine And Engine Cooling
THE BOLT COULD BREAK, CAUSING THE ENGINE TO STALL AND NOT RESTART, raises the risk of A CRASH.
Remedy & full details
DEALERS WILL CHECK THE IDLER SHAFT BOLT. IF THE BOLT CANNOT BE REMOVED BY HAND, A MODIFIED IDLER SHAFT BOLT WILL BE INSTALLED. IF THE BOLT IS LOOSE ENOUGH TO BE REMOVED BY HAND, A NEW IDLER GEAR, IDLER SHAFT, AND A MODIFIED IDLER SHAFT BOLT WILL BE INSTALLED. THE RECALL BEGAN ON DECEMBER 20, 2005. OWNERS MAY CONTACT MITSUBISHI FUSO AT 1-856-467-4500.
ON CERTAIN MEDIUM DUTY TRUCKS, THE CYLINDER HEAD IDLER GEAR SHAFT BOLT MAY HAVE BEEN INSUFFICIENTLY TIGHTENED DURING INITIAL ASSEMBLY. CONTINUED OPERATION IN THIS CONDITION COULD CAUSE THE BOLT TO LOOSEN, RESULTING IN ABNORMAL NOISE FROM IMPROPER GEAR ALIGNMENT.
Moderate08V224000
Power Train:Automatic Transmission
THE SHIFT CONTROL LEVER MAY BECOME INOPERATIVE, OR THE PHYSICAL SHIFT LEVER POSITION ON THE SHIFT LEVER HOUSING GEAR INDICATOR MAY NOT MATCH THE ACTUAL GEAR SELECTION AT THE TRANSMISSION.
Remedy & full details
DEALERS WILL INSTALL A MODIFIED AUTOMATIC TRANSMISSION SHIFT CONTROL LEVER ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 6, 2008. OWNERS MAY CONTACT MITSUBISHI FUSO AT 1-856-467-4500.
MITSUBISHI FUSO IS RECALLING 15,549 MY 1999-2004 FE639, FE649, AND FG639 TRUCKS; MY 2001-2004 FE640, AND MY 2003-2004 FH210 TRUCKS EQUIPPED WITH AUTOMATIC TRANSMISSIONS. NORMAL HEAT EMANATING FROM THE EXHAUST PIPE MAY CAUSE THE AUTOMATIC TRANSMISSION SHIFT LINKAGE TO DEFORM. THE EFFORT REQUIRED TO OPERATE THE AUTOMATIC TRANSMISSION SHIFT CONTROL LEVER MAY INCREASE IF THE LINKAGE BINDS DUE TO THE DEFORMATION.
Moderate05V304000
Power Train:Automatic Transmission:Lever And Linkage:Floor Shift
THE EFFORT REQUIRED TO OPERATE THE A/T SHIFT CONTROL LEVER MAY INCREASE IF THE LINKAGE BINDS DUE TO RUST BUILD-UP.
Remedy & full details
DEALERS WILL INSTALL A MODIFIED A/T SHIFT CONTROL LEVER ASSEMBLY. THE RECALL BEGAN ON SEPTEMBER 26, 2005. OWNERS MAY CONTACT MITSUBISHI FUSO AT 1-856-467-4500.
ON CERTAIN MEDIUM DUTY TRUCKS, RUST BUILD-UP ON THE AUTOMATIC TRANSMISSION (A/T) SHIFT LINKAGE MAY CAUSE THE LINKAGE TO BIND. RUST BUILD-UP IS ACCELERATED IN GEOGRAPHIC LOCATIONS THAT ARE SITUATED NEAR LARGE BODIES OF SALT WATER, OR IN REGIONS WITH HEAVY SNOW/ICE MELTING COMPOUND USAGE IN WINTER MONTHS.
Moderate05V303000
Engine And Engine Cooling
IF THE VEHICLE IS CONTINUALLY OPERATED IN THIS CONDITION, THE BRACKET MAY BREAK APART, CAUSING THE TRANSMISSION TO DROP OUT OF ALIGNMENT WITH THE DRIVE TRAIN.
Remedy & full details
DEALERS WILL INSTALL A MODIFIED REAR ENGINE SUPPORT BRACKET. THE RECALL BEGAN ON SEPTEMBER 26, 2005. OWNERS SHOULD CONTACT MITSUBISHI FUSO AT 1-856-467-4500.
ON CERTAIN MEDIUM DUTY TRUCKS, THE REAR ENGINE SUPPORT BRACKET IS COMPOSED OF MATERIALS OF INSUFFICIENT STRENGTH. NORMAL VEHICLE VIBRATIONS MAY CAUSE THE BRACKET TO CRACK.
Complaint volume
Volume alone is not a fault rate — popular vehicles attract more reports. Read it next to the severity mix below.
What owners reported happened
0Crashes
0Fires
0Injuries
1Deaths
Across 1 complaints. Severity Index 10.00.
Severity Index weights each complaint's reported outcome (death ×10, injury ×4, fire ×3, crash ×2) and divides by total complaints. It measures how severe reports are, not how often faults occur.
What owners report most
Power Train:Automatic Transmission — 1 reports
What to do
Find your 17-character VIN on the driver's door jamb or the base of the windscreen.
Check it against NHTSA's official lookup at nhtsa.gov/recalls — the authoritative record for your exact car.
Book the repair with any franchised dealer. Safety recall work is free, with no time limit and regardless of who owns the car now.
Other model years
2001
Numbers in brackets are open recall campaigns for that year.
Questions
Does an open recall mean the car is unsafe to drive?
Not usually. NHTSA issues a "do not drive" or "park outside" advisory when a defect is dangerous enough to keep you out of the car — those are flagged Critical above. Everything else should be repaired promptly but is not an immediate stop-driving order.
Do I pay for recall repairs?
No. Federal law requires the manufacturer to fix a safety recall free of charge, including parts and labour, whether or not you are the original owner.
Why are there complaints but no recalls?
Complaints are unverified reports filed by owners. They can prompt an investigation, but many never become recalls — either the fault isn't safety-related or it isn't widespread.
From the same data desk
Independent sites, same maintainer, same open-data standards.