2000 Oldsmobile Alero Recalls & Complaints

DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

GM will notify owners, and dealers will install two key rings and an insert in the key slot or a cover over the key head on all ignition keys, free of charge. The recall began on September 9, 2014. GM's number for this recall is 14350.

This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 3, 2014, that they are recalling 5,877,718 model year 2000-2005 Chevrolet Impala and Monte Carlo, 1997-2003 Chevrolet Malibu, 2004-2005 Malibu Classic, 1999-2004 Oldsmobile Alero, 1998-2002 Oldsmobile Intrigue, 1999-2005 Pontiac Grand Am and 2004-2008 Pontiac Grand Prix vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.

DEALERS WILL REPLACE THE HAZARD WARNING SWITCH. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438, PONTIAC AT 1-800-620-7668, OR OLDSMOBILE AT 1-800-630-6537.

CERTAIN PASSENGER VEHICLES HAVE HAZARD WARNING SWITCHES THAT MAY EXPERIENCE SOLDER JOINT CRACKING CAUSED BY RAPID TEMPERATURE TRANSITIONS AND THE SOLDERING PROCESS. IF SOLDER JOINT CRACKING OCCURS AND RESULTS IN AN OPEN CIRCUIT, THE TURN SIGNALS/HAZARD LAMPS BECOME INTERMITTENT OR INOPERATIVE.

DEALERS WILL REPLACE THE CONSOLE LATCH MECHANISM.

VEHICLE DESCRIPTION: THESE VEHICLES DO NOT COMPLY WITH THE OCCUPANT PROTECTION REQUIREMENTS OF FMVSS NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." THE CONSOLE COVER ON THESE VEHICLES DOES NOT STAY CLOSED WHEN A SPECIFIED VERTICAL LOAD IS APPLIED.

DEALERS WILL DISABLE THE 5TH/REVERSE INHIBITOR BY REMOVING A RETAINING PIN AND REPLACE THE SHIFTER ASSEMBLY.

VEHICLE DESCRIPTION: CERTAIN PASSENGER VEHICLES EQUIPPED WITH MANUAL TRANSAXLES (RPO M86) FAIL TO COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 114, "THEFT PROTECTION." WHEN A DRIVER ATTEMPTS TO SHIFT FROM 5TH GEAR TO REVERSE, A SHIFT INHIBITOR CAUSES THE TRANSMISSION TO BE MECHANICALLY IN 4TH GEAR EVEN THOUGH THE SHIFT LEVER INDICATES REVERSE GEAR.